Minelab Equinox 700&900 "V6" 15'' & 11" & 6" Coil stiffener and Repair

This is not the cheapest coil stiffener on eBay, that are usually printed at low quality at a high speed to keep the cost down on print time.

All my units are 3D printed with quality in mind and without cutting corners on quality.

Available in RED or BLACK.

Other colours available on request, please contact me.

Each stiffener apart from the 6 inch coil version comes with 2 securing cable ties.

We also supply optional replacement coil bolt kits for Equinox 700 and 900 or other detectors that use 8mm hole size and less than 50mm in width across the coil mounting lugs.

These coil mounting bolt come with 3D printed thumb screws with easy grip flanged nuts.

Included in the kit is our unique tension adjuster key and coil to shaft alignment tool.

The tensioning key is used to gauge the correct friction to keep your coil aligned without needing to over tighten.

The Coil to Shaft alignment tool is a great asset when attaching the coil to the shaft and getting the holes in the shaft and coil to align when fitting the coil bolt, roughly align the holes and then use the tool to to centralise the holes before fitting the bolt.

Great if you suffer from arthritis, have big or muddy hands.

The threaded bolt and nut is made from industrial grade Nylon and not like some sold on eBay 3D printed.

I always advise on checking the coil mounting rubbers are not to worn, if in doubt always replace with new ones to suit your shaft end.